Chavant Photo Gallery

Selected examples of Chavant products


Most viewed - Bunt's Concept 400
tire31.jpg
Bunt's Concept 400 Series Tire #311875 viewsThree inserts were produced : plain face, bunt's name and the tire size.
tire3.jpg
Bunt's Concept 400 Series Tire #031867 viewsThe framework is now ready to have the styling clay applied. ...........end of Framework
WS_Framework2.gif
Bunt's Concept 400 Series Tire #00498 viewsThe framework for a one sixth segment of half the finished tyre was fabricated to act as a support for the styling
tire44.jpg
Bunt's Concept 400 Series Tire #44493 viewsThe tire featured on the 'TEN' Anniversary Bike - designed and built by Streetfighters-Switzerland
tire43.jpg
Bunt's Concept 400 Series Tire #43433 views400mm of wide tire. It looks and feels like a real tire. If I hadn't been so pushed for time, I would have looked around for some rubber essence so that it smelt like rubber!
tire42.jpg
Bunt's Concept 400 Series Tire #42429 viewsThe finished tire showing the sidewall lettering.
tire41.jpg
Bunt's Concept 400 Series Tire #41420 viewsThe whole thing is turned over and the process repeated.
tire39.jpg
Bunt's Concept 400 Series Tire #39361 viewsThis image shows both mould halves ready to have the inner skins bolted into position. The rubber is then poured into the void between the mould and inner skin, and the mould halves are bolted together.
tire40.jpg
Bunt's Concept 400 Series Tire #40358 viewsAfter the rubber has cured, the mould sections can be removed from the tire.
tire38.jpg
Bunt's Concept 400 Series Tire #38356 viewsAn epoxy laminate skin is laid up to act as a support for the rubber.
tire2.jpg
Bunt's Concept 400 Series Tire #02348 viewsPrior to applying the styling clay, the main surface area receives two coats of shellac to aid adhesion for the clay.
tire35.jpg
Bunt's Concept 400 Series Tire #35347 viewsThe finished mould bolted together .............end of Mould Tooling
44 files on 4 page(s) 1