Chavant Photo Gallery

Selected examples of Chavant products


Last additions - Bunt's Concept 400
WS_Framework2.gif
Bunt's Concept 400 Series Tire #00The framework for a one sixth segment of half the finished tyre was fabricated to act as a support for the stylingJul 18, 2016
tire44.jpg
Bunt's Concept 400 Series Tire #44The tire featured on the 'TEN' Anniversary Bike - designed and built by Streetfighters-SwitzerlandJul 18, 2016
tire43.jpg
Bunt's Concept 400 Series Tire #43400mm of wide tire. It looks and feels like a real tire. If I hadn't been so pushed for time, I would have looked around for some rubber essence so that it smelt like rubber! Jul 18, 2016
tire42.jpg
Bunt's Concept 400 Series Tire #42The finished tire showing the sidewall lettering.Jul 18, 2016
tire41.jpg
Bunt's Concept 400 Series Tire #41The whole thing is turned over and the process repeated.Jul 18, 2016
tire40.jpg
Bunt's Concept 400 Series Tire #40After the rubber has cured, the mould sections can be removed from the tire.Jul 18, 2016
tire39.jpg
Bunt's Concept 400 Series Tire #39This image shows both mould halves ready to have the inner skins bolted into position. The rubber is then poured into the void between the mould and inner skin, and the mould halves are bolted together.Jul 18, 2016
tire38.jpg
Bunt's Concept 400 Series Tire #38An epoxy laminate skin is laid up to act as a support for the rubber.Jul 18, 2016
tire37.jpg
Bunt's Concept 400 Series Tire #37This shows one half completed. Jul 18, 2016
tire36.jpg
Bunt's Concept 400 Series Tire #36The tread surface area of each mould is built up with sheet wax to the thickness required for the rubber. Jul 18, 2016
tire35.jpg
Bunt's Concept 400 Series Tire #35The finished mould bolted together .............end of Mould ToolingJul 18, 2016
tire34.jpg
Bunt's Concept 400 Series Tire #34Two more sections to go.........
Jul 18, 2016
44 files on 4 page(s) 1